« previous next »
Pages: [1]   Go Down

Author Topic: Bent Firing Pin Shadow2  (Read 1359 times)

0 Members and 1 Guest are viewing this topic.

Offline Ohmslaw

  • Full Member
  • ***
  • Posts: 135
Bent Firing Pin Shadow2
« on: July 03, 2020, 04:28:13 PM »
My S2 wouldn’t fire today right off bat worked fine last time out. Tore it down firing pin stuck finally got it out and it’s bent not broke bent. I have the CGW lighter hammer and firing pin springs haven’t installed longer firing pin yet. Is that the cause or dry firing which hasn’t been that much. Only little over 500 rounds through gun only month old. Channel appears clean maybe just faulty pin?
Thanks
Ohmslaw
Logged

Offline SoCal

  • Sr. Member
  • ****
  • Posts: 611
Re: Bent Firing Pin Shadow2
« Reply #1 on: July 04, 2020, 09:09:55 AM »
I would contact CZ-USA. sounds like a bad firing pin.  Even if you plan on using a CGW pin CZ should know, just in case there was/is a problem at the factory.  I have never heard of CZ's bending firing pins.
Logged
If I had known how much better being retired is than working I would have done it FIRST.

Offline Ohmslaw

  • Full Member
  • ***
  • Posts: 135
Re: Bent Firing Pin Shadow2
« Reply #2 on: July 04, 2020, 10:17:04 AM »
Thanks I emailed them already if no response I’ll call. I never heard of it either. I think it’s to soft should be harder and broke maybe possible not bent
Thanks
Ohmslaw
Logged

Offline Grendel

  • Administrator
  • Hero Member
  • *****
  • Posts: 8955
  • 'Live Long, and Prosper'
Re: Bent Firing Pin Shadow2
« Reply #3 on: July 04, 2020, 10:48:27 AM »
One thread please
Logged
Corruptissima re publica plurimae leges - Tacitus

Inter arma enim silent leges - Cicero

I wasn't born in America, but I got here as fast as I could.
Pages: [1]   Go Up
« previous next »