Little intro "how i handle de- and installing the firing pin" being not adequately supplied with the tool.
I put the slide on the table upside down, i take a deep breath and imagine the universe in perfect balance
Left palm is pressing slide down to the table (righty) while left thumb and left pointer finger reach the firing pin stop.
The special firing pin disassembly and Kadet tuning tool (ball pen) or its plastic guide rod presses the FP as straight as possible into the FPstop and lifts him slowly up to get secured by the two fingers feeling the movement up. Until the spring loaded FP pops out an gets stopped with intend by the right hands fingers holding the tool too. For the first "shots" i would recomend a barrier.
The use of a ball pen was more easy in the beginning than the guide rod. Until i was able to push in the firing pin straight without slipping of the back end of the FP when pushing him in. Especially when reinstalling
For installing i put in the spring and insert the FP with the flat end up.
Left palm pressure is finding a place on the slide to alow the thumb-pointer- tweezers to hold the FPstop at it`s channel.
From the right side i press the FP as far in as i can place the FPstop on the biggest diameter of the FP or already on the flatted end. While holding the FP upright and pressing him down on the FP - i push the FP with the tool against the springforce linear completely down in its channel. Until the stop and pin clicking into the contemplated position. With a little routine it can be done unobserving randomly.
If you can do this on the first try - you are my hero. Better have a barrier..
Pics mixed tools but in right order, incomplete, but you get it
Dissassembly
Finger tweeze the FPstop as you press in FP and lift up FPstop with the tool -
be aware of sudden spring supported release of the FP
assembly- imagine your fingers beeing part in the process
against the springforce
linear
on the biggest diameter of the FP or already on the flatted end
press the FP in to place the FPstop on the biggest diameter of the FP
finger tweezers to hold the FPstop at it`s channel
push FP completely down its channel
stop and pin clicking
No oil or liqid fluna in the FP channel
Wiped and Q-tiped it off before.
