« previous next »
Pages: [1]   Go Down

Author Topic: CZ 75 40S&W  (Read 1352 times)

0 Members and 1 Guest are viewing this topic.

Offline Cousin Vinnie

  • Jr. Member
  • **
  • Posts: 58
CZ 75 40S&W
« on: April 19, 2021, 08:06:29 AM »
Hello Forum members; I have a BNIB Full Size CZ 75 in 40 S&W and would like to get a 357 Sig barrel for it. Any ideas where one can be found? I have searched the net and checked the aftermarket barrel makers, but no to no avail! Or do I just stick with the 40 S&W and just use lighter bullet weights and forget about any conversion?
Any leads would be appreciated......
Logged

Online Earl Keese

  • Hero Member
  • *****
  • Posts: 5192
Re: CZ 75 40S&W
« Reply #1 on: April 19, 2021, 08:19:25 AM »
If your .40 S&W barrel is .550 diameter, you need to buy an SP01 9mm barrel and have the chamber reamed for .357sig.
Logged

Offline Fuzzy Sights

  • Hero Member
  • *****
  • Posts: 1210
  • > Dirt
Re: CZ 75 40S&W
« Reply #2 on: April 19, 2021, 12:12:07 PM »
Have had three of these done.  CZ Custom is the place for you.  Not cheap, but you will not be disappointed.  Good Luck.

JW
Logged
Vivat et res publica!

Think of me as a Newbee who types a lot.

Offline Cousin Vinnie

  • Jr. Member
  • **
  • Posts: 58
Re: CZ 75 40S&W
« Reply #3 on: April 21, 2021, 08:26:57 AM »
Update: I talked to CZ Custom and they can make the 357 Sig barrel. They would require me to send in the pistol so the barrel can be fitted. Total cost would be about $300 which is not bad. Also, lead time is 6-8 weeks....again, not bad!
Will keep the forum updated....
Logged

Offline Fuzzy Sights

  • Hero Member
  • *****
  • Posts: 1210
  • > Dirt
Re: CZ 75 40S&W
« Reply #4 on: April 22, 2021, 11:10:47 PM »
You will not be disappointed.  Wish you all the best. 

JW
Logged
Vivat et res publica!

Think of me as a Newbee who types a lot.
Pages: [1]   Go Up
« previous next »