CZ P-10F OR SR

[trucker512000]

Just purchased at GrabAGun for $429. Does anyone know if you have to use a plate adapter or what footprint is the optic cut? I sent 2 emails to CZ support with no answer. I see where there are different plate adapters, but what footprint is the optic cut? No mention online or in manual. I don't want to pay $40- $70 more for adapter plate.

[CDKJudoka]

You need an adapter plate, and you can buy them from CZ-USA or CZ Customs, if they are in stock. It uses the same adapters that the OR Shadow 2 does.


https://czcustom.com/cz-parts-all/red-dot-mounting/p10-s2-optic-ready-pistol-plates.html

[Joe L]

Just to clarify for trucker512000--The screw pattern on the gun does not match any sight directly, it only matches an adapter plate, which must be chosen to match the sight you want to install. 

So, once you have the adapter plate, trial fit the sight on the plate and install the screws supplied with the sight.  Then MAKE SURE the screws do not extend out below the adapter plate.  If the screws are too long, they will bottom out on the slide cut before the sight is tight.  Then remove the sight from the plate, install the plate on the slide, use blue loctite on the screws, then install the sight on the adapter plate, again with a drop of blue loctite. 

Then go zero the sight and have some fun with your new setup. 

Joe L

[GasGuzz]

If I may... The USA P-10 S/C/F all use/have the same slide OR cut (for S RMR/Holosun-507C)?
Thanks.

[SI VIS PACEM PARRABELLUM]

If I may... The USA P-10 S/C/F all use/have the same slide OR cut (for S RMR/Holosun-507C)?
Thanks.

Not sure where you got this but read this link from CZ-USA regarding the USA made P10 line. They use a plate the same as the overseas guns.
https://le.cz-usa.com/us-made-cz-p-10-or-family/

[rgunner1]

If I may... The USA P-10 S/C/F all use/have the same slide OR cut (for S RMR/Holosun-507C)?
Thanks.

No they all use the standard factory adaptor plate as previously described by Joe M, which is the same cut as the S2 OR Model.