S2C Optic Plate

[viking499]

Where do you recommend I get an optic plate for my S2C that will accept a Holosun 507C footprint?

[Whereisit]

Correct me if I'm wrong but isn't the s2 compact the same as the full size and the 507c is on a rmr footprint? If so then I recommend Athena. I had chpws aluminum for both my p10c and F. Did not like them at all. Always came loose and the screws always stripped. I use loctite and a torque wrench.

Athena plates are steel and use better quality screws. The plates also had my rmr sitting lower and better fit. No hang over.

https://athenaprecision.com/products/cz-shadow-trijicon-rmr-steel-red-dot-adapter-plate

A pop up might come up to save some money or free shipping.

[Born2vette]

I put the DPP titanium plate on my P10f, cheap and thin.  Have about 2000 rounds of competition shooting on it with no issues. FYI I used their screws to mount the plate to the pistol (I cleaned them and applied blue loctite) and the Holosun screws to mount the optic to the plate.

https://www.amazon.com/DPP-Titanium-Compatible-Trijicon-SRO-CZ-SDW-02/dp/B0DTJSNKPV?ref_=ast_sto_dp

[Whereisit]

I put the DPP titanium plate on my P10f, cheap and thin.  Have about 2000 rounds of competition shooting on it with no issues. FYI I used their screws to mount the plate to the pistol (I cleaned them and applied blue loctite) and the Holosun screws to mount the optic to the plate.

https://www.amazon.com/DPP-Titanium-Compatible-Trijicon-SRO-CZ-SDW-02/dp/B0DTJSNKPV?ref_=ast_sto_dp

Forgot about the dpp. I have a friend that uses them and never had an issue. At the time the P10 plates were out of stock.

If you don't go with Athena I'd def give the dpp a try.

[steel]

I purchased an optic plate with BUIS from CGW to mount my Trijicon RCR on my S2C.  The BUIS co-witness very well with the existing front sight.  I haven’t had any issues.