« previous next »
Pages: [1]   Go Down

Author Topic: Need help with CZ 82  (Read 1330 times)

0 Members and 1 Guest are viewing this topic.

Offline noreaster

  • Newbie
  • *
  • Posts: 2
Need help with CZ 82
« on: November 22, 2009, 03:32:12 PM »
I'm hoping someone has a parts gun and may be able to help me out.  After I refinished my 82, I noticed the disconnector was able to rotate in its hole when the slide was off - apparently lost a pin (#23, headed pin on the blow up diagram).  Same pin is used on the other side of the frame as well.  Anyone got a parts gun, interested in selling this pin?  Appreciate any help.
Logged

Offline PTGT_Neon

  • Sr. Member
  • ****
  • Posts: 384
    • Efficient Mileage
Re: Need help with CZ 82
« Reply #1 on: November 22, 2009, 03:54:35 PM »
You could give CZ-USA a call and ask for the item.  It'll be a CZ-83 part.  So you might as well ask for two to make it symmetrical.  The 82 has a flat side where the 83 has a round head on the pin. 

I broke pin 25.  CZ USA didn't have a replacement and said I could drill out the frame in two places for the new pin design and associated new spring design.  My solution was to make a new pin out of some stock steel from Lowes.  I did a good job so it works fine. 
Logged

Offline noreaster

  • Newbie
  • *
  • Posts: 2
Re: Need help with CZ 82
« Reply #2 on: November 24, 2009, 02:14:56 AM »
Thanks, CZ came through, order is on the way.
Logged
Pages: [1]   Go Up
« previous next »