Author Topic: Problem with sights (CZ ProTek 2)  (Read 2920 times)

0 Members and 1 Guest are viewing this topic.

Offline steinbauer

  • Newbie
  • *
  • Posts: 6
Problem with sights (CZ ProTek 2)
« on: November 19, 2013, 02:51:40 PM »
I bought CZ Pro Tek 2 with manual safety few months ago and I am having problems with the sights (tritium,Novak style rear).
When I align sights in a usual way it shoots high and front tritium dot is higher than rear two.When I align dots it shoots straight but top of the front sight is about 1.2 mm lower than it should be.It is hard for me to shoot based on dot alignment only.Not to mention that both tritium dots and sights should align properly at the same time.
I called and I was told to make the adjustment based on dots......I would like to know what options do I have to fix this problem.Is there a longer front site that can be put in?
Addenum: I just called and I will bring it back.We'll put either bigger tritium or fiberoptic site in the front.
« Last Edit: November 20, 2013, 12:44:21 PM by steinbauer »

Offline Bossgobbler

  • Sr. Member
  • ****
  • Posts: 890
Re: Problem with sights (CZ ProTek 2)
« Reply #1 on: December 02, 2013, 11:08:54 PM »
what was the fix?

Offline bmadd

  • Jr. Member
  • **
  • Posts: 88
Re: Problem with sights (CZ ProTek 2)
« Reply #2 on: August 19, 2014, 05:51:19 PM »
What was the outcome ?

Offline cdhbrad

  • Full Member
  • ***
  • Posts: 287
Re: Problem with sights (CZ ProTek 2)
« Reply #3 on: August 20, 2014, 09:00:55 AM »
I thought the Pro-Tek 2 was built with an elevation adjustable only rear sight or did you spec fixe sights with the Heinie 2 dot system?  If the latter, I had those on a DW Valor and never could get used to the sight picture.  Changed them to a Harrison rear and Dawson FO front.  That same set up will work on your Pro-Tek as well because the rear sight cut is the "Novak" style cut as is the Harrison.   

Offline bmadd

  • Jr. Member
  • **
  • Posts: 88
Re: Problem with sights (CZ ProTek 2)
« Reply #4 on: September 16, 2014, 05:17:16 PM »
Ill check my sights when my protek arrives.

Offline 1SOW

  • Hero Member
  • *****
  • Posts: 15006
  • GO GREEN - Recycle 9MM
Re: Problem with sights (CZ ProTek 2)
« Reply #5 on: September 16, 2014, 05:39:29 PM »
The Pro-Tek with 3 dots,  "likely" should have the three dots aligned ON the target = center mass.
This for reference: 
http://www.czfirearms.us/index.php?topic=60117.msg412002#msg412002