« previous next »
Pages: [1]   Go Down

Author Topic: Cz 550 question  (Read 1747 times)

0 Members and 1 Guest are viewing this topic.

Offline Cz527lux

  • Newbie
  • *
  • Posts: 3
Cz 550 question
« on: July 18, 2016, 10:41:50 PM »











« Last Edit: December 02, 2016, 06:27:31 PM by Cz527lux »
Logged

Offline AZ_CZ

  • Hero Member
  • *****
  • Posts: 3294
Re: Cz 550 question
« Reply #1 on: July 18, 2016, 10:58:42 PM »
I don't have your specific model and it's been awhile since I pulled the action on my 550 FS, but I don't recall the action being attached to the lower bottom metal or the magazine housing. I attached a link to the PDF manual with a parts diagram. Wish I could be of more assistance. Good luck with you issue.

http://cz-usa.com/hammer/wp-content/uploads/2014/04/cz550-555_en.pdf
Logged
CZ Fanbot since 1996

Offline Rhino

  • Hero Member
  • *****
  • Posts: 663
Re: Cz 550 question
« Reply #2 on: July 19, 2016, 02:36:52 AM »
If someone glass bedded the action it may be super tight, I have a sporterized 98k Mauser like that. Or someone didn't use enough mold release.
Logged

Offline Cz527lux

  • Newbie
  • *
  • Posts: 3
Cz 550 question
« Reply #3 on: July 19, 2016, 11:11:03 AM »






« Last Edit: December 02, 2016, 06:28:55 PM by Cz527lux »
Logged

Offline Rhino

  • Hero Member
  • *****
  • Posts: 663
Re: Cz 550 question
« Reply #4 on: July 19, 2016, 02:39:40 PM »
Take the action screws out and hit the stock against a table or floor, bench, etc. make sure it is padded. If it is just really tight it should come out, if not you can break the stock and not be better off.
Logged

Offline 2bytandem

  • Jr. Member
  • **
  • Posts: 31
Re: Cz 550 question
« Reply #5 on: September 16, 2016, 09:45:13 PM »
Those Battue models are interesting!


Sent from my iPhone using Tapatalk
Logged
Pages: [1]   Go Up
« previous next »