« previous next »
Pages: [1]   Go Down

Author Topic: CZ 97B Trigger Job ?  (Read 3438 times)

0 Members and 1 Guest are viewing this topic.

Offline jim.c

  • Full Member
  • ***
  • Posts: 183
CZ 97B Trigger Job ?
« on: June 21, 2016, 05:07:51 PM »
I'm looking at a CZ 97B and I think I would like to have CZC do a trigger job on the pistol.  Can anyone tell me what's involved in a CZC trigger job ?  What parts are changed out what polishing is done etc. ? What SA/DA trigger pull can be expected with the trigger job and how much does a trigger job on the 97B cost.  Thanks !!!
Logged

Offline SI VIS PACEM PARRABELLUM

  • Hero Member
  • *****
  • Posts: 5847
Re: CZ 97B Trigger Job ?
« Reply #1 on: June 21, 2016, 07:22:16 PM »
If you are going to send it out your best bet is to give CZC a call and tell them what you are looking for from the pistol so they can get you in the ball park as far as price. There is a gamut you can run as far as parts depending on what you specifically desire.
Logged

Offline bigdipper

  • Newbie
  • *
  • Posts: 8
Re: CZ 97B Trigger Job ?
« Reply #2 on: July 01, 2016, 03:22:52 PM »
You could do it yourself pretty easily.  CGW has a lot of drop in parts that will allow you to do what every you need.  I just put in a CGW hammer/sear combo with an SA trigger.   I think I also put in the extended FP and lighter springs.   Polished up a few areas and it is good to go.
Logged

Offline PappaWheelie

  • Full Member
  • ***
  • Posts: 225
  • "This is war, and in war, time is of the essence."
    • The Children's Bread
Re: CZ 97B Trigger Job ?
« Reply #3 on: August 04, 2016, 10:43:15 PM »
Logged
Member, Gun Owners of America
CC: CZ 2075 RAMI BD in PappaWheelie Invisible 15 Round RAMI Holster
Homeboy: CZ 97 BD, Underwood 45 Super 120 Grain Xtreme Defender ammo
UBG: CZ 75 SP-01 Tactical Urban Grey Suppressor-ready
-all w/ CGW Short Reset Kit/1485-T2 Disco, 5 "Thick" Trigger, polished SA tooth
Pages: [1]   Go Up
« previous next »