What's your P-07 DA/SA trigger pull ###'s

[DOC 1500]

Please weigh in with what Mods you've done to your P07 Gen 2. ONLY.(Not Lights & lasers ) EX.. like sanding, polishing, Springs etc..
And please tell us your unexaggerated DA/SA
 Trigger PULL #'s..

[DOC 1500]

Using many videos and  threads,
I polished all internals to a chrome-like finish ( there are some machine marks, can't go too far with sanding and polishing).
Installed myself from CGW,
reduced block plunger spring,
18# hammer spring,
 reduced firing pin spring,
Reduced power trigger return spring
Relieved some pressure on the trigger bar Spring
I now have a 9#10oz DA...2# 12oz SA like buttered butter  : )

[toddzilla36]

Bone stock, maybe 1500 rounds, DA 10lbs +3-5 oz. SA 5-5.5lbs. Lyman trigger gauge. Best advice I can give is shoot it and get stronger unless you have a physical limitation. This gun and my P09 have the best mechanical  accuracy of any firearm I've ever owned.

Sent from my SM-G920V using Tapatalk

[M1A4ME]

My P07 is a DUTY (or Gen 1) pistol and is bone stock inside.  3&1/4 lb. SA with about an 8&1/2 lb. DA.

The P09 was "monkeyed with" by me.  I didn't like the long pull after the firing pin block was lifted out of the way so I removed a small amount of metal from the sear to cause less trigger movement between firing pin block movement and hammer release.  No polishing of anything.  3&3/4 lb. SA and a DA of 9 lbs???  Been awhile since I measured it.

I'm guessing I got lucky.

[bigmatt17073]

My P-07 gen 2 has a 7.5 pounds DA and 2.5 pound SA trigger pulls. I have polished the action, reduced trigger bar spring tension, and installed the reduced trigger return spring, Race hammer, short reset kit, and P 07/09 spring kit from CGW.

[wdbutcher]

I have a stock 2016 Gen 2, P-07. Using a cheap trigger gauge, I have a 3.25# SA and about a 9# DA trigger pull. All I've done is polish the trigger, sear, and hammer pins. I also polished the trigger bar and reduced the tension on the trigger bar spring.