So I decided to detail strip and clean my P-10C after about 350 rounds - since it was new (I did a field strip and clean when new initially). As a first side note, I found it quite dirty as the carbon had caked with the factory grease (was heavily greased where you could not see or get to during a field strip). I used the CZ manual to guide the disassembly and also watched several videos. Turned out it was pretty straight forward and went well allowing a thorough gun cleaning (and proper -re-lube).
My 1 question about re-assembly is about reinstalling the extractor, specifically the pin. The CZ manual says to re-stake it once installed. However, none of the videos did this - and I recognize that the videos were not done by CZ. Since this pin is fairly tight going back in (carefully punch pounded back in), I don;t see why CZ would say to re-stake it? On the slide inside pin hole you can clearly see where CZ had staked it from the factory (wasn't a punch stake, rather a "bar" stake on the slide edges). Is re-staking really needed? And if so, what tool would be appropriate?
