Author Topic: Extended Magazine Release  (Read 428 times)

0 Members and 1 Guest are viewing this topic.

Offline aandabooks

  • Jr. Member
  • **
  • Posts: 55
Extended Magazine Release
« on: December 07, 2018, 11:04:57 PM »
Does such a thing exist for the Rami?  I just put on a set of Cool Hand grips and an extended mag release would be nice to have.

Offline TNman

  • Full Member
  • ***
  • Posts: 217
Re: Extended Magazine Release
« Reply #1 on: December 08, 2018, 05:45:22 AM »
IDPA   |   USPSA  |   NRA

CZ PCR   |   RAMI BD   |   Shadow 2   |   P-10 C

Sig P320 C & F
Sig P226 Legion
Sig P320 X-Carry
Springfield XDS Mod 2 45

Offline MarkLH

  • Newbie
  • *
  • Posts: 5
Re: Extended Magazine Release
« Reply #2 on: December 21, 2018, 12:20:16 PM »
I just posted in another thread, inquiring re: an extended mag release for the Rami...
my short thumb doesnt quite REACH the stock mag release button... the extended part referenced looks like it would just sticks OUT from the frame a bit more, but the button would ? not extend further toward the rear of the grip...

anyone have actual experience with it?? 

and: is this part a complicated install ? ( ie. requires a gunsmith ) Im pretty mechanically capable, and patient - but have no gunsmithing experience....tnx! -Mark

Offline Practical Shooter

  • Full Member
  • ***
  • Posts: 311
  • Life's just too short
Re: Extended Magazine Release
« Reply #3 on: December 21, 2018, 08:14:55 PM »
I have installed the CGW extended magazine release (part 32ES) on my SP-01.
I needed it for the same reasons as yours, hard to reach.The extended release is perfect and resolved that issue. 
Its installation was not very hard to do, but it all depends on your abilities to do it.
This video might help you out. I also show some little tricks to do the job


Offline MarkLH

  • Newbie
  • *
  • Posts: 5
Re: Extended Magazine Release
« Reply #4 on: December 21, 2018, 08:30:24 PM »
good to hear it helped.. !  ill watch the video,  THANK YOU!

-Mark