Author Topic: HBI Bren 2 Controls (Trigger, Selectors, Charging Handle)  (Read 3320 times)

0 Members and 1 Guest are viewing this topic.

Offline 1nQU1s1t0r

  • Newbie
  • *
  • Posts: 12
Re: HBI Bren 2 Controls (Trigger, Selectors, Charging Handle)
« Reply #15 on: April 29, 2020, 03:05:25 PM »
I've added all three of these to my Bren. Look great, feel great, work great. Easy to follow instructions. Highly recommended.

Offline MeatAxe

  • Hero Member
  • *****
  • Posts: 1577
Re: HBI Bren 2 Controls (Trigger, Selectors, Charging Handle)
« Reply #16 on: June 21, 2020, 08:50:34 PM »
I installed the charging handle and a safety lever yesterday. Can’t say I was impressed with the supplied spiral roll pins. Had difficulty getting them in (they actually started unraveling and otherwise refused to fit in their holes, so went back to the original CZ pins, which went in just fine. Not sure if it is a size or quality issue with the HBI pins, but they absolutely would not go in right. Maybe if the pin holes were chamfered a bit more, the supplied pins would go in easier. So don’t throw away your original pins if you do this mod.