P10C Optics Ready (95130) Out of Stock Everywhere

[aflevine]

Want to take the green dot plunge.  While I speak Glock, I just don't want to get an MOS when, for around the same money, I can get a much better weapon.  Everywhere I've checked has these on back-order with no clear date for delivery.  Nobody is saying that they expect them in shortly.  So, getting on every list and waiting is ....

Anyone else hearing anything different?

[steelsig]

Nope. Same everywhere. I've seen where a couple people have them. Order an optics plate from CZ customs because they don't come with plates. CZ has not made their plates available yet as far I have seen. Or buy an old model and have it milled. Love my milled p-10 c and the ambi mag release which you is not on the new version.

[aflevine]

I'm expecting CZ to compete with Glock's MOS.  The market is surely there.  They cannot afford any major manufacturing/QA gaffs. 

SteelSig, curious where you went for your holster?

[steelsig]

I'm expecting CZ to compete with Glock's MOS.  The market is surely there.  They cannot afford any major manufacturing/QA gaffs. 

Sttlsig, curious where you went for your holster?

If you are asking me where I get my holsters, I use several suppliers. Currently I ANR and BlackRhino are my favorites.

[aflevine]

Thank you.  I'll take a look at both.

[aflevine]

I'd appreciate some advice.  I can get a new-ish 91520 model P-10C made in 2018 for $300 to $350.  At that point, I'd need to send it off to be milled to be optics ready.  The big unknown is what CZ is going to do with their sights on the optics ready version when it comes out?  If they're designed to work with an RMR or similar, then the iron sights are likely a bit higher as a design feature right out of the box.  Can anyone with an optics ready P-10 comment on whether the OOTB sights work well or they felt they had to change them? 

[aflevine]

After sagely advice, I'm going with a model 91520 from October 2018 and then having it milled.  The problem is the iron sights.  CZ has evidently been wrestling with a new set of sights that would literally need to come up more than .5 inches (roughly .45" for the red dot then .1 more for the adapter plate).  The existing sights become useless given that kind of lift, so something different is needed.  Having the slide custom milled doesn't create as much of a rise.  While I'm at it, I'm getting Dawson sights with a tritium front at 1/3 co-witness.  Also, I'm buying the trigger enhancement that I'll install.