Author Topic: Errant first shot_ P09_9mm  (Read 797 times)

0 Members and 1 Guest are viewing this topic.

Offline Cujo99

  • Jr. Member
  • **
  • Posts: 52
Re: Errant first shot_ P09_9mm
« Reply #30 on: December 01, 2019, 04:35:46 PM »
Quote
Correct me if I'm wrong, but I believe you're talking about the bottom side of the firing pin Channel that rubs on the next round in the magazine.
That area should always be stoned and Polished to a mirror finish. If not done just causes a lot of resistance to the slide, and in this case enough resistance that the slide does not lock up properly.

I was referring to the breech face (should have said so)  but I did also lightly break the sharp edge on the front & rear of that bar that runs along the bottom side of the firing pin channel  as it was leaving a slight line on the next round in the magazine.  I did the rear corner also to allow a smoother hammer cock during recoil (I usually do this on all my CZ's) I just hadn't got around to doing this one yet.

We'll see what happens when I get out on my range tomorrow as I would like to confirm improvement.

I have other shooting commitments that come first so those have priority.

 

anything