« previous next »
Pages: 1 [2]   Go Down

Author Topic: Grip Screw Problem  (Read 5002 times)

0 Members and 4 Guests are viewing this topic.

Offline SoCal

  • Sr. Member
  • ****
  • Posts: 603
Re: Grip Screw Problem
« Reply #15 on: September 20, 2021, 04:59:54 PM »
Quote from: Tok36 on September 20, 2021, 03:56:28 AM
   I used rubber O rings under the screw heads to keep the grips screws in place on my CZ 97 when i was running the factory aluminum grips. It may be worth a try.

X2 on the o-rings with aluminum grips.
Logged
If I had known how much better being retired is than working I would have done it FIRST.

Offline schutz85C

  • Full Member
  • ***
  • Posts: 307
Re: Grip Screw Problem
« Reply #16 on: December 26, 2021, 01:27:00 AM »
You can also cut an end off an electrical wire shrink wrap tube as an O ring.
Logged
CZ 85 Combat, NRA Lifer.

Offline Dan Wesson

  • Full Member
  • ***
  • Posts: 109
Re: Grip Screw Problem
« Reply #17 on: December 26, 2021, 07:43:02 PM »
This stuff is the best—
Vibra-Tite VC-3

Easily reuse the screws 3-4 times before reapplication is needed.


Sent from my iPhone using Tapatalk
Logged
Pages: 1 [2]   Go Up
« previous next »