Author Topic: P-07 with Aimpoint ACRO?  (Read 539 times)

0 Members and 1 Guest are viewing this topic.

Offline K.O.A.M.

  • Newbie
  • *
  • Posts: 3
P-07 with Aimpoint ACRO?
« on: November 17, 2019, 02:03:49 PM »
Has anyone had their P-07 milled for an Aimpoint ACRO? I'd like to get mine done and was wondering if anyone had recommendations.
Thanks in advance for your help.

Offline davekoch

  • Full Member
  • ***
  • Posts: 177
Re: P-07 with Aimpoint ACRO?
« Reply #1 on: November 19, 2019, 12:34:43 PM »
 Primary Machine will mill your slide for you.


I don't have an Acro, but I had them mill my P10C for an RMR cut and a Glock dovetail in front of the optic. They also refinished my slide with Cobalt Cerakote and installed my sights for no extra charge. They mounted my Holosun 507C and it's a very tight fit in the slide.  I was very pleased with their work and also sent my P07 slide to them for the same thing. Turnaround for the P10C was three weeks.



Offline Stuart

  • Hero Member
  • *****
  • Posts: 8447
Re: P-07 with Aimpoint ACRO?
« Reply #2 on: November 19, 2019, 05:13:43 PM »
Has anyone had their P-07 milled for an Aimpoint ACRO? I'd like to get mine done and was wondering if anyone had recommendations.
Thanks in advance for your help.

We have a couple in queue to do for a customers. Will post up when done.
stuart@czcustom.com
czcustom.com

Offline DOC 1500

  • Hero Member
  • *****
  • Posts: 1864
Re: P-07 with Aimpoint ACRO?
« Reply #3 on: November 19, 2019, 05:19:01 PM »
I'll put my Kudos in for primary machines, they did my po9 for a Vortex Viper and cerakoted the slide beautiful work. The Optic in the slide is very tight,  I don't think you could put a hair between the optic and the slide. When I practice I draw from Kydex holster every time  and there is no wear  of the cerakote on the slide.
JOHN 3:16
2 COR.5:17
A Lie is a Lie even if everybody believes it ,
The Truth is the Truth even if nobody believes it !!!

 

anything