CZ PISTOL CLUBS > CZ Polymer Pistols, the new wave

P-07 with Aimpoint ACRO?

(1/1)

K.O.A.M.:
Has anyone had their P-07 milled for an Aimpoint ACRO? I'd like to get mine done and was wondering if anyone had recommendations.
Thanks in advance for your help.

davekoch:
 Primary Machine will mill your slide for you.


I don't have an Acro, but I had them mill my P10C for an RMR cut and a Glock dovetail in front of the optic. They also refinished my slide with Cobalt Cerakote and installed my sights for no extra charge. They mounted my Holosun 507C and it's a very tight fit in the slide.  I was very pleased with their work and also sent my P07 slide to them for the same thing. Turnaround for the P10C was three weeks.


Stuart:

--- Quote from: K.O.A.M. on November 17, 2019, 02:03:49 PM ---Has anyone had their P-07 milled for an Aimpoint ACRO? I'd like to get mine done and was wondering if anyone had recommendations.
Thanks in advance for your help.

--- End quote ---

We have a couple in queue to do for a customers. Will post up when done.

DOC 1500:
I'll put my Kudos in for primary machines, they did my po9 for a Vortex Viper and cerakoted the slide beautiful work. The Optic in the slide is very tight,  I don't think you could put a hair between the optic and the slide. When I practice I draw from Kydex holster every time  and there is no wear  of the cerakote on the slide.

Navigation

[0] Message Index

Go to full version