Tristar / canik p100/120 frame widths

[Jrtatonka]

Does anybody know, or have a micrometer / caliper and can measure the width of the frames? It looks like the clones don't have that step in the frame directly above the grips.
Thanks

[legionofdoon]

I don't have a micrometer but I'm looking at my P100 now and there is a step or cut where the beaver tail is directly above the grip at the rear of the gun where the hammer pivot pin is. It looks 1/8 on either side per measuring tape.

Sent from my Moto G (4) using Tapatalk

[legionofdoon]

Its dusty I know.

Sent from my Moto G (4) using Tapatalk

[Practical Shooter]

Does anybody know, or have a micrometer / caliper and can measure the width of the frames? It looks like the clones don't have that step in the frame directly above the grips.
Thanks

I have a P120 and a micrometer, but I am not too sure where you want the measurement to be taken.

[legionofdoon]

What do you need the info for? If it's for a specific reason just ask that reason and I'm sure you will get a better answer. BTW mine is one of the earlier P100s it's serial number is between 1 and 5 so I'm not sure if they changed anything since then.

Sent from my Moto G (4) using Tapatalk

[Jrtatonka]

If you look at a p01 there is a step directly above the grips.  They made the frame thicker. Im curious if the clones are the thickness of the original 75 or sp01 series

[legionofdoon]

There is no outward step on my P100. It had a cut out as per my pic otherwise it's smooth from the grip to the slide. At least on mine.

Sent from my Moto G (4) using Tapatalk

[legionofdoon]

That being said I use a stealth gear AWIB for the P01 and it fits perfectly.

Sent from my Moto G (4) using Tapatalk

[Practical Shooter]

I have 26.06mm or 1.026"
Good luck