« previous next »
Pages: [1]   Go Down

Author Topic: SAR K12 DA/SA Conversion  (Read 1413 times)

0 Members and 1 Guest are viewing this topic.

Offline fuelbender

  • Newbie
  • *
  • Posts: 4
SAR K12 DA/SA Conversion
« on: May 03, 2021, 10:32:17 AM »

I was ab;e to convert my K12 from SA only to DA/SA with Tanfoglio hammer, disco, trigger and trigger bar; all drop in! Wjile i was at it I added a OT stop.
Logged

Offline HollowDawg

  • Full Member
  • ***
  • Posts: 312
Re: SAR K12 DA/SA Conversion
« Reply #1 on: May 03, 2021, 10:42:01 AM »
Great looking grips!! What are they? Haven't seen a lot of choices in grips for my K12.
Logged

Offline fuelbender

  • Newbie
  • *
  • Posts: 4
Re: SAR K12 DA/SA Conversion
« Reply #2 on: May 03, 2021, 02:15:09 PM »
Thanks, I made them from grip blanks from ebay.
Logged

Offline jwc007

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8762
Re: SAR K12 DA/SA Conversion
« Reply #3 on: May 03, 2021, 03:04:53 PM »
Very Nicely done!!!  8)  Congratulations!  :)
Logged
"Easy is the path to wisdom for those not blinded by ego." - Yoda


For all of those killed by a 9mm: "Get up! You are not dead! You were shot with a useless cartridge!"

Offline fuelbender

  • Newbie
  • *
  • Posts: 4
Re: SAR K12 DA/SA Conversion
« Reply #4 on: May 07, 2021, 12:09:15 PM »
CZ grips will fit but you have to trim the lower rear part of the grip to clear the frame.
Logged
Pages: [1]   Go Up
« previous next »