Question on CZ shadow 2 magazine release button

[no.vale.la.pena]

For Shadow 2 magazine releases that have the removable button attached via a torx screw, is the angle of the button adjustable? I.e. can the stock button be affixed to the release at a different angle than is the standard configuration?   

Thanks!

[nonamehavei]

Yes the angle is adjustable. IMHO be prepared to deal with some locktite on the screw holding the paddle on to the release. Following advice from this forum I used the tip of a soldering iron to heat the head of the screw up before removal, it helped a lot!

[no.vale.la.pena]

Ok thank you! much appreciated. I figured so but I just wanted to verify.

 I was considering running one an SP01 but I was only interested if the button could be adjusted to face towards the the top of the slide so I wouldn’t have as much downward thumb movement, otherwise the added size would not benefit me.

[nonamehavei]

Ok thank you! much appreciated. I figured so but I just wanted to verify.

 I was considering running one an SP01 but I was only interested if the button could be adjusted to face towards the the top of the slide so I wouldn’t have as much downward thumb movement, otherwise the added size would not benefit me.

Yep that’s exactly how I run mine, have one on both shadow 2s of course but also on a TSO and have one retrofitted to a P01, all pointed up at the slide.