Author Topic: Stock issue  (Read 1433 times)

0 Members and 1 Guest are viewing this topic.

Offline rudemoose

  • Newbie
  • *
  • Posts: 2
Stock issue
« on: June 24, 2022, 12:44:20 PM »
Hi all,
I have a 457 varmint, and I bought a Boyds stock for it. OK the stock fits perfectly, BUT the floor plate (trigger guard?) has the plastic grip on it. Even when removed it does not fit. Called Boyds, they told me to find an aftermarket, because they don't make one. Any thoughts as to where I can get one? Is there even one made for it?

Thanks,
Matt

Offline skin

  • Sr. Member
  • ****
  • Posts: 869
Re: Stock issue
« Reply #1 on: July 21, 2022, 04:23:36 AM »
 Can you take the plastic grip off? If so, try to fit the bottom metal on. Try it without the barreled action installed. I bought an at one thumbhole stock that I had to do a lot of minor fitting to, including touching up where the bottom fit into the stock.
 Back to your stock, you may have to trim the plastic some. They just slap it on and send it out.
 I hope this helps.

Offline Gebogen

  • Newbie
  • *
  • Posts: 9
Re: Stock issue
« Reply #2 on: August 05, 2022, 01:16:37 PM »
Are you talking about the triggerguard/magazine metal? If so, Area 419 makes an aluminum piece.

 

anything