cz 457 mtr

[Jim R]

Just purchased a used CZ 457 MTR with walnut stock, any info on what rings,scope and bi-pod would be helpful. Thanks

[Born2vette]

I have the same rifle and do benchrest competition. Your intended use/preferences may differ, mine is equipped with the following:

https://www.area419.com/product/cz457-scope-base/

https://vortexoptics.com/vortex-strike-eagle-4-24x50-ebr-4-moa-riflescope.html (no longer available, I bought aT closeout for about $250)

https://vortexoptics.com/vortex-pro-series-30mm-rings.html

Love my MTR, enjoy!

[2morechains]

I second the Area 419 scope rail.  Slides on over the factory 11 deg dovetails and is very secure.  As far as which height to get (15MOA, 30MOA, 50MOA) that depends on how far you want to shoot and how much elevational travel your scope has. 

[BarkingAnt]

Third vote for 419 rail. Figure out what zero range you want based on vertical adjustment of your scope and then select the amount of cant of the rail. If you want to zero 50 yards or less rail cant should be about half the scopes total vertical adjustment. Usually this works

There's plenty of online information about this. Also on both of mine, I have two, the fit is really tight. I had to tap both of mine on with a hammer after I lubed them with grease.

I also have same rings, I got the lowest ones.

[Jim R]

Thanks to all for your advice. JR

[Fyrfyter]

Always looking for info on what to get next

[2morechains]

Always looking for info on what to get next

Depends on your application or intended purpose I suppose. 

[Cinimod]

One of the must have’s is a bubble level either mounted on the scope or picatinny. I prefer the scope mount bubble level.

[Born2vette]

One of the must have’s is a bubble level either mounted on the scope or picatinny. I prefer the scope mount bubble level.

The Area 419 mount has one.