P-10C OR low co-wittnes irons.

[Lostinthewoods]

I'm planning on installing a Holosun EPS on the Holosun plate made for K series.  Will this give me a low co-wittness with stock height irons, or will I need taller sights like the Night Fission OR Stealth?

Sent from my SM-A716U using Tapatalk

[Auslander]

I doubt the stock sights will give a lower 1/3 co-witness.

Even the RMR, which is a very low profile RDS requires a taller sight set. Unsure how your holosun and a RMR compare.

CZ USA’s web store carries fairly inexpensive sight sets.

The below link should take you to the RMR et al sight set. These are serrated. The 3-dot ones may be cheaper.

https://shop.cz-usa.com/0571070031.html

Search “P10 co witness” on the store to cut out some time.

I have the extra tall 3-dot set that is necessary for the much taller Leupold DPP. Nothing fancy but does the job.

Good luck.


Sent from my iPhone using Tapatalk

[Lostinthewoods]

I doubt the stock sights will give a lower 1/3 co-witness.

Even the RMR, which is a very low profile RDS requires a taller sight set. Unsure how your holosun and a RMR compare.

CZ USA’s web store carries fairly inexpensive sight sets.

The below link should take you to the RMR et al sight set. These are serrated. The 3-dot ones may be cheaper.

https://shop.cz-usa.com/0571070031.html

Search “P10 co witness” on the store to cut out some time.

I have the extra tall 3-dot set that is necessary for the much taller Leupold DPP. Nothing fancy but does the job.

Good luck.


Sent from my iPhone using Tapatalk

I measured.  The RMR deck height is .330" and the Holosun is .275.  The plate will be here tomorrow.   I'll measure everything assembled and order the correct height sights.  I like as  low a co-wittness as possible..

Sent from my SM-A716U using Tapatalk