Is there enough room to keep the rear site dovetail on a Suppressor Ready model of the P-10F and have it milled? I've sent an email or two out to milling shops, but I need to decide whether or not to cancel the SR order and order an OR, or keep the SR and get it milled. SR will be $400 after rebate and the OR would be $320 after rebate. Milling seems slightly cheaper than a factory threaded barrel and much cheaper than aftermarket. I also wouldn't run suppressed but would put a comp on it. Thanks!
ETA: Did some measuring with my OR P-10C and it doesn't look like there will be room to not go beyond the factory cut.
