As mentioned in another of my threads, I've been looking for a mag extension for my factory, Mec-Gar, 10-rd, SP-01 mags. Finding one is complicated by my addition of what I think is some variation of a CZ factory magwell (which I purchased from Armory because CZ was out of stock in what I thought I needed, a "large frame" version (
https://shop.cz-usa.com/aluminum-magwell-large-frame-black40280.html). Mine does NOT match any of the images on the CZ site -
https://shop.cz-usa.com/catalogsearch/result/index/?q=+magwell+small+frame.
Note, on that CZ page, versions id'd "small frame" and "large frame". Both versions have a rather rectangular recess cut into the back/inside wall. They differ in the shape of the contour at the front/inside edge - small is squared-off, large is rounded. Also, the front lip of the small is a lot fatter than the large, large has a much shallower rake which tapers to less than 1/16" at the very front.
However...what I got from Armory - purchased using this product page (
https://www.armorycraft.com/product-page/cz-75-aluminum-magwell) - and which fits both my pistol and the included factory mags just fine, has squared-off front AND rear inside edges, NO rear recess, and the shallow front lip rake. The images on the Armory site show all colors but green with a rounded (large version) front/inside edge and shallow lip rake. Green has a squared-off front/inside edge, "fat" front lip. All have the rear recess. [What I received is not pictured. Nor is it shown on the CZ webiste (at least not at the link I included above).] I'd provide a pic but I'm not an Imger user.
So...suggestions on what do I have? [Yes, I've asked Armory but the part numbers they get from CZ are not the same sequence that CZ shows on their site - and, again, what they show is not what I received.] Sorry for my OCD but I create detained spreadsheets for all my firearms builds and I'm trying my best to accurately ID everything in this pistol.
Thanks.
