Author Topic: CZ USA-HAMMER  (Read 828 times)

0 Members and 1 Guest are viewing this topic.

Offline marc

  • Newbie
  • *
  • Posts: 4
CZ USA-HAMMER
« on: December 24, 2005, 01:38:12 AM »
Hello fellow shooters!

I m 36 years old, have been shooting IPSC Since 3 years and I just switch my STI by one CZ SP01  :D

I just put the CZ USA custom hammer in my SP-01, the trigger break at 3lbs with a lot of pre travel in SA !

but the weight of the pre travel is very close to the total of the weight of release and gives a very light trigger feeling and its very difficult to take off the pre travel without release the hammer

I polish too all the internal parts

Is it possible to change this   ?

In advance thanks and sorry for my bad english  

Marc
 
Back to top  
 

 


Denis-Altuna

  • Guest
CZ USA-HAMMER
« Reply #1 on: December 24, 2005, 07:01:36 AM »
Hello Marc
I the long trigger reset is because of the sear.
There is a small "leg" in L on the sear touching the trigger. This part is for the release of the hammer when you are shooting and also for the reset in SA . If this part is a little bit small, you will have a long reset. The best is to test differents sears, and to find one with a longer "L".


Denis

Offline marc

  • Newbie
  • *
  • Posts: 4
CZ USA-HAMMER
« Reply #2 on: December 25, 2005, 01:37:00 PM »
Hi Denis.

Thank you for the information !

Marc

 

anything