Author Topic: MTAC Holster + P01 molding = 40P??  (Read 2887 times)

0 Members and 1 Guest are viewing this topic.

Offline boostedxt

  • Newbie
  • *
  • Posts: 2
MTAC Holster + P01 molding = 40P??
« on: September 01, 2010, 08:09:21 PM »
I have the MTAC IWB holster for my XD. I was looking over their website and saw they make a P01 molded sleeve for it. I would assume that being the lowers are the same the P01 kydex sleeve would work for the 40P, right?

I am trying to find a good IWB holster and am either going to go with this or get a Galco second amendment holster.

thoughts?
joe

Offline CZ4Life

  • Newbie
  • *
  • Posts: 9
Re: MTAC Holster + P01 molding = 40P??
« Reply #1 on: September 16, 2010, 11:06:58 PM »
I just ordered an IWB from www.CrossbreedHolsters.com
I got the Super Tuck model
I've heard nothing but good reviews.  My brother owns 3 of them and wears them everywhere.
I contacted the owner, Mark, and he said the CZ P-01 holster will fit the 40P perfectly.
I can't wait to get it!

Oh, if you use the coupon code - NRA - you will get 10% off ;)
« Last Edit: September 16, 2010, 11:13:56 PM by CZ4Life »

Offline grosventregeorge

  • Jr. Member
  • **
  • Posts: 79
Re: MTAC Holster + P01 molding = 40P??
« Reply #2 on: October 08, 2010, 03:07:23 AM »
It should work. From what I have read anything for the P-01 will work for the 40P. A lot of the holsters for the SP-01 will work and in some cases holsters for the Ruger 97 will work.
CZ40P and CZ Model 3 300 WSM

Offline KFD147

  • Sr. Member
  • ****
  • Posts: 938
    • Hammer Down Sports
Re: MTAC Holster + P01 molding = 40P??
« Reply #3 on: October 08, 2010, 09:37:21 AM »
The P01 M-tac will not fit the 40P. Different slides. The 40P is longer than the p-01 and the kydex shell is tapered at the end. I have both and have tried them. No Go!



Jason 8)
www.hammerdownsports.com
Copperas Cove Pistol Club Member
Temple Gun Club Member
IDPA Member
CZ-USA supporter

"Owning a firearm makes you a shooter just like owning a guitar makes you a musican."

Offline grosventregeorge

  • Jr. Member
  • **
  • Posts: 79
Re: MTAC Holster + P01 molding = 40P??
« Reply #4 on: October 08, 2010, 09:45:14 AM »
The P01 M-tac will not fit the 40P. Different slides. The 40P is longer than the p-01 and the kydex shell is tapered at the end. I have both and have tried them. No Go!



Jason 8)
Good to know.
CZ40P and CZ Model 3 300 WSM