CZ-75 Stainless Picture Thread

[skipper]

Looks very very nice there Skip

Thanks, I have been seeing these for awhile and decided to dress up my ss CZ's. Thinking of grips too, but I really like the Houge and CZ rubber.

[DenStinett]

Thinking of grips too, but I really like the Houge and CZ rubber.

I like the Hogue Rap Around Grips myself
With these Torx Screws;
http://czscrews.angelfire.com/

[skipper]

Den,thanks for that site. I am a fan of torx head screws. Recently I had to use a torx head driver to remove a stripped hex head in one of my 1911's.

[DenStinett]

I am a fan of torx head screws

Here's a couple pics with my three with Torxs:

[skipper]

Those look good. I will keep a watch on his site, there was post that orders were on hold until the end of the month.

[enaz40]

Those look good. I will keep a watch on his site, there was post that orders were on hold until the end of the month.

Family matters resolved, I'm ready to ship again.  http://czscrews.angelfire.com/index.html

[DenStinett]

Family matters resolved, I'm ready to ship again.  http://czscrews.angelfire.com/index.html

Cool....... they are well worth the $$$$$$

[Daddy-O]

Third attempt at posting pics   

[jcm2710]

...and this is a pic of my CZ75B Stainless matte.

I'm still struggling a bit with accuracy (compared with other pistols, but it's the shooter's fault!).  I think I need thinner grips to improve on my shooting.

[scribe556]

I could not stand just looking at Joe's base plates any longer.  Can you see the smile on the 75 SS? They are nice and match the matte finish perfectly.

I got a bunch of 17 rounders with the plastic baseplates.  I could put these matte stainless plates on my two plain 16 rounders for extra bling!

[Kraaken]

where did you find the baseplates?  Neat!  Do they come in shiny SS?

[Kraaken]

Woo Hoo!  Finally got my 75B SS today!  Ordered extras - halfchecked cocobolo grips and SS screws, along with some sweet custom mag base plates.

I'm a happy camper!

Trying again to load up the pix: 

and a close up of the custom baseplate

[DenStinett]

where did you find the baseplates?  Neat!  Do they come in shiny SS?

Yes, check this out...They're too nice
http://www.czfirearms.us/index.php?topic=25806.0

[ZardozCZ]

If it uploads, this is slow fire weak hand (only) at 10'. I've shot less than 20 rds weak handed in my life. Took my time getting left hand and right eye in sync.



This is with stock new 'Special Edition' stainless in 9mm. I'm loving it!

[czechyoself]

Nice gun Kraaken. The only thing I would change on those baseplates would be to angle the rear of the plate to sit flush with the pistol. Due to the material thickness, I think there is room to do this and it would improve the look. They look exceptionally well polished though. The guy that does these is one of those rare people that gives a bleep about what they produce.