« previous next »
Pages: [1]   Go Down

Author Topic: Quick CZ-40 Question  (Read 3338 times)

0 Members and 2 Guests are viewing this topic.

Offline bullsi1911

  • Hero Member
  • *****
  • Posts: 309
Quick CZ-40 Question
« on: May 28, 2003, 07:00:32 AM »
I put a CZ-40 on layaway on friday, and I have a quick question- just above the slide stop on the 'drivers side' of the slide there is a little machined divot.  Does that have a purpose?

You can see the 'divot on the picture on the CZ-USA website, so I know that it just isn't mine that has it.
Logged

mbott

  • Guest
Quick CZ-40 Question
« Reply #1 on: May 28, 2003, 04:24:51 PM »
Alignment mark for disassembly.  It aligns over the safety red dot when you take the pistol apart and then when you re-assemble.  See the maintenance instructions for details.

--
Mike
Logged

Offline bullsi1911

  • Hero Member
  • *****
  • Posts: 309
Quick CZ-40 Question
« Reply #2 on: May 28, 2003, 06:19:40 PM »
Gotcha... one of them RTFM errors ;)

Just downloaded the manual from the CZ-USA site, and see that the divot is a witness mark for disasembly of the DAO version.  Thanks!
Logged

HungWeiLo

  • Guest
Quick CZ-40 Question
« Reply #3 on: May 30, 2003, 09:57:03 AM »
Not just for the DAO, which I think was only available as the Colt version.  The SA/DA uses the same divot while taking it apart.
Logged
Pages: [1]   Go Up
« previous next »