CZC Rear Sight Pusher

[TX_Southpaw]

Anyone have experience with this?

http://czcustom.com/czrearsightpusher.aspx

Is this better than a brass punch?  I'm curious if this would be more precise than a brass punch when making adjustments.

[Bishop112]

I'm sure it is way more accurate. Mainly because the mechanical advantage of threads over the guessed smack with a hammer. If i could justify 100 bucks for one I would get one. But I have been thinking of making one...

[TX_Southpaw]

Right now I'm deciding on whether I should finish my first project or just add another to the queue.

Buying this would allow me to finish a project or two, but prevent me from adding some nice pistols.  Decisions decisions...

[1SOW]

Bishop,  I did the same.  Crude but works on my CZs and my Sig.  Had to buy the fine thread bolts, but otherwise was free.
Welded a steel frame.The vice jaws are aluminum with some leather inserts.  Drilled and tapped with fine thread bolts.  The pusher is adjustable was turned smooth in a drill press.   A brass cap fits over the tip.  I've only needed it once.     Oh yeah, its reversible.
   

[Bishop112]

i like it! I will have to make an adaption of that. Good Job!

[1SOW]

It flexes just the tiniest bit, so I always meant to add a "bridge" over the top, but haven't needed it again.  I used it for installing and sighting in a Comp. rear at the range on a 75B.  I also did another shooters sight at the range.

[Bishop112]

Hrrmmm... looks like I will be busy tomorrow.... I'll post pics with how it turns out... Thanks for the idea 1SOW !

[Bishop112]

I finished the sight pusher yesterday.... I will take pics tomorrow and show ya what I cam up with. Very similar design to 1SOW.... thanks for the inspiration! hopefully I will get a chance to take it to the range and fine tune my sights in the next couple days.

[1SOW]

I absolutely can't stand having to 'add' windage or elevation guesses to my sight picture.  I want POA=POI.
I got the HAJO height adj. rear on my Shadow and it came dead on for windage, so hopefully I won't need my rube goldberg  again.

 

[viking499]

Sow, do you have a pic of your adjuster from the other side?  What diameter bolts did you use?

[Bishop112]

Sorry its taken so long to put some pictures up ... and sorry the quality of the pics isnt that good... i think next time i will drag out my wifes camera. This is sight pusher mk1.... I can already think of a few more things I want to change (which is why i left lots of meat on the side to make adjustments). But here it is.

[1SOW]

Nice work! EXCELLENT!

Milled bottom?  TIG or MIG welded bridge?   How did you make the pusher tip?  Looks solid as a rock.   
You'll be able to set the sights perfectly at the range now.

[Xenogy]

Does that screw have a swivel head like a C clamp? Where did you get that from?

Also looks like aluminum tray and the rest is steel. I think I may try building and thread both sides for left and right adjustment. You could fit a dial indicator through the hole on the opposite side for fine tuning windage.

Sent from my ASUS Transformer Pad TF300T using Tapatalk 4

[Bishop112]

yes I milled the bottom from some aluminum stock I had laying around and the Tig welded the bridge out of stainless steel scrap. The pusher I got from mcmaster carr item #92432A456. The pusher is exactly like a c-clamp tip and seems to work great without marring the surface. I have used them for making jigs before so I knew just what to look for. The 3/8 set screws that hold the slide have nylon tips That I got from another project long ago.