« previous next »
Pages: [1]   Go Down

Author Topic: Comp Hammer Install  (Read 1811 times)

0 Members and 1 Guest are viewing this topic.

Offline Bishop112

  • Sr. Member
  • ****
  • Posts: 597
Comp Hammer Install
« on: October 01, 2013, 11:27:15 PM »
I Installed a comp hammer in my 75B not to long ago and was shooting from double action when i found a little click that I dont remember having before I put in the hammer. I narrowed it down to the sear sliding down the "half cock" notch when firing from double action with the hammer "fully" down. Is this normal? I usually only shoot from half cock so I think that is why i didnt notice right away.
Logged

Offline Jimsan

  • Newbie
  • *
  • Posts: 10
Re: Comp Hammer Install
« Reply #1 on: October 21, 2013, 07:28:18 PM »
I installed a Comp hammer over the weekend and had the same thing happen.  I'm not sure I understand what you figured out it was.  Did not find a solution for it? 
Logged

Offline Magsz

  • Full Member
  • ***
  • Posts: 352
Re: Comp Hammer Install
« Reply #2 on: October 25, 2013, 02:30:20 AM »
Logged

Offline painter

  • Hero Member
  • *****
  • Posts: 6231
Re: Comp Hammer Install
« Reply #3 on: October 25, 2013, 07:11:14 AM »
Logged
I had the right to remain silent...

but not the ability.

Offline Bishop112

  • Sr. Member
  • ****
  • Posts: 597
Re: Comp Hammer Install
« Reply #4 on: October 25, 2013, 04:10:21 PM »
Logged

Offline Bishop112

  • Sr. Member
  • ****
  • Posts: 597
Re: Comp Hammer Install
« Reply #5 on: October 25, 2013, 04:12:20 PM »
Quote from: painter on October 25, 2013, 07:11:14 AM
Have you guys seen this post by David?

http://www.czfirearms.us/index.php?topic=59149.msg382354#msg382354

Yup, saw that and got the picture from him. I am going to try it and see what happens.
Logged
Pages: [1]   Go Up
« previous next »