thin grips

[ronster79]

I see a lot of grip posts but I wondered if anyone made any thin grips. thinner than the factory standard.

[rugerista]

http://czcustom.com/CZ-75-85-TS-Grips-Aluminum-Plastic-Rubber.aspx

[JoePfeiffer]

I've heard many good comments about these guys, but haven't bought from them myself.  Without measuring, I don't know if these are actually thinner than the factory grips. 
http://www.marschalgrips.com/cz75_82-thin/thincz75-82.html

[MetalGravy]

http://czcustom.com/CZ-75-85-TS-Grips-Aluminum-Plastic-Rubber.aspx

Doesn't appear as though they have any grips for the 82/83.

[rugerista]

Try this...

http://www.marschalgrips.com/cz75_82-thin/thincz75-82.html

http://grips4u.net/category/pistol-grips/cz/cz-82-83/

[MetalGravy]

Have you used them?  Are you able to activate the mag release with the thinner grips?

[rugerista]

I have the original plastic.  I can activate the mag release without any problems.  It sounds like your mag release is not working properly. 

[MetalGravy]

That could be, it is very, very stiff.  However, what I meant was that my thumb can't reach the mag release w/o having to adjust my grip.  That is because of the swelling in the grip panels right behind the release.

[ronster79]

I activate with my index finger. it works good. since the mag release is ambidextrous.

[MetalGravy]

Was the button really stiff and difficult to press at first?  My 83 is from 1991, so I would think that it is well broken-in.

[JoePfeiffer]

They get worse with wear.

sent using CPIP (see RFC 1149)

[JimThornTX]

I activate with my index finger. it works good. since the mag release is ambidextrous.

I do this with my CZ 82. Thumb side mag release is almost impossible to push in.

[MetalGravy]

Well, this should help if I need to replace it

https://www.youtube.com/watch?v=Ps0GyD_dO1s