..357 Sig conversion..

[dannyvi]

 Can I convert a P-01 to this caliber?

[Stuart]

No, breechface is too small a dimension.

[dannyvi]

Thanks, Stuart ! Any CZ convertible to this caliber? I know most ..40 caliber pistols are.!

[Stuart]

Just the .40 guns as they share the same breechface.

We have done for P06, TS 40SW and 75B 40 pistols.

[NOSAJ19]

When 357sig became the major calibre to have (we cant use 40cal) for IPSC here in Australia. Folks convert their 9/38 STI Edges & similar 1911/2011 handguns. They had gunsmiths open up the breach face to accept the 40cal case. The bigger issue was getting sig rounds to feed reliably out of the mags.

I have a CZ TS 40 that has a 9mm barrel fitted & reamed to accept a 357sig case (remanufactured 40cal case is what I use) case. 100% reliable, using TS 40 mags.

[maleante]

What is the ballpark estimate of a conversion on a customer supplied gun?

[euro]

Rather than start a new thread for basically the same question, does anyone know if there is a .357SIG barrel to fit a CZ 40?

I can't see any reason why not but a Google search revealed nothing concrete or even speculative.

[Stuart]

What is the ballpark estimate of a conversion on a customer supplied gun?

PM me.

[Stuart]

Rather than start a new thread for basically the same question, does anyone know if there is a .357SIG barrel to fit a CZ 40?

I can't see any reason why not but a Google search revealed nothing concrete or even speculative.

not that I have seen as a drop in ready to go.