Author Topic: CZ 75 Phantom - compatability of parts?  (Read 1297 times)

0 Members and 1 Guest are viewing this topic.

Offline yakabebe

  • Jr. Member
  • **
  • Posts: 36
CZ 75 Phantom - compatability of parts?
« on: September 11, 2015, 05:23:41 AM »
Was wanting to switch out the plastic/polymer??? recoil guide rod with a steel one...there are a few to chose from the various sites

Was wondering if when it states as it does below but doesnt specifically mention the Phantom...are they one and the same?:

CZ 75 & TS  Stainless Steel FULL LENGTH Guide Rod
CZ 75 Stainless Steel FULL LENGTH Guide Rod for the CZ 75/85  family.
Fits in the SP01, SP01 Shadow, 97B, CZ 75's (with hole), and Tactical Sport (TS) without further modification.
Guide rods may be a little awkward to install using Flat Wire Spring.
*We suggest purchasing the Wire Recoil Spring.*
The flat on the guide rod back needs to be aligned with barrel feet for installation.
Slide must already have the hole drilled for long guide rod.

Also I bought mine 2nd hand.  I had a look at the shadow and it has a bush on the rod with the spring but my model does not...tried it on mine and it CLEARLY doesnt fit...is there a bush missing from my gun?

TIA

Offline yakabebe

  • Jr. Member
  • **
  • Posts: 36
Re: CZ 75 Phantom - compatability of parts?
« Reply #1 on: September 13, 2015, 09:10:20 PM »
Bump

 - was wondering if any one had an answer to this?

TIA

Offline Tommy B

  • Newbie
  • *
  • Posts: 11
Re: CZ 75 Phantom - compatability of parts?
« Reply #2 on: September 14, 2015, 01:55:48 AM »
I have the ss guide rod for the sp01 in my phantom and it works fine.