Author Topic: SP-01 Tact: Hammer Won't Drop In Double Action  (Read 4759 times)

0 Members and 1 Guest are viewing this topic.

Offline tdogg

  • Hero Member
  • *****
  • Posts: 2712
  • Two Alpha!
Re: SP-01 Tact: Hammer Won't Drop In Double Action
« Reply #15 on: January 07, 2016, 05:29:24 PM »
Your shaking the loctite before using it right?  It's fresh loctite?  I don't know if I would use red loctite on anything that I may want to take apart again, especially a small set screw.  Blue seems to be holding just fine on all my triggers but these are comp guns.

Cheers,
Toby
This forum rocks!

Offline rich63

  • Sr. Member
  • ****
  • Posts: 566
Re: SP-01 Tact: Hammer Won't Drop In Double Action
« Reply #16 on: January 07, 2016, 05:44:34 PM »
tdogg,

To answer your question yes and quite vigorously. The threadlocker red I have is perhaps 6 months old. It appears I am not prepping the surface good enough.

 From what my aging eyes can see, all the residue has been removed. We'll see how they are tomorrow. If they are still loose, both guns are getting packed up and put into my safe til I can figure out what my next move will be.

Probably what I will do later on in the spring is purchase another 85c trigger with over and pretravel screws and another 6SAO straight trigger and start over. Currently both are out of stock at CGW.

rich63

Offline harleypower69

  • Newbie
  • *
  • Posts: 17
Re: SP-01 Tact: Hammer Won't Drop In Double Action
« Reply #17 on: January 08, 2016, 11:09:18 AM »
Had a very similar problem with my reset screw backing out. I was convinced my trigger reset spring was broken. After numerous posts and checking everything over once again I was chagrinned to see the screw had backed out of the trigger. I did Loctite it back in and it runs just like it should. I was pretty peeved that one little screw could shut my gun down. Upon further research I found that some competitive shooters remove it completely as it can be a "weak link". Good luck and enjoy.

Chris

Offline harleypower69

  • Newbie
  • *
  • Posts: 17
Re: SP-01 Tact: Hammer Won't Drop In Double Action
« Reply #18 on: January 08, 2016, 11:11:34 AM »
PS Here is the link to my cluster. http://www.czfirearms.us/index.php?topic=75752.0

Offline rich63

  • Sr. Member
  • ****
  • Posts: 566
Re: SP-01 Tact: Hammer Won't Drop In Double Action
« Reply #19 on: January 08, 2016, 11:38:41 AM »
harleypower69, 

I have had the gun completely disassembled and all looks good. Appreciate the link. I will give it a good read.

rich63