« previous next »
Pages: [1]   Go Down

Author Topic: trying to remove the factory rear sight on P-01  (Read 1503 times)

0 Members and 2 Guests are viewing this topic.

Offline rjinaz85308

  • Jr. Member
  • **
  • Posts: 34
trying to remove the factory rear sight on P-01
« on: June 15, 2016, 10:06:26 PM »
is there a set screw in there.  I can't seem to get these loose  Even with my sight pusher.

Thx
Rick
Logged

Offline cntrydawwwg

  • Hero Member
  • *****
  • Posts: 5254
Re: trying to remove the factory rear sight on P-01
« Reply #1 on: June 15, 2016, 10:13:49 PM »
Trying to think back, I think mine may have been staked just a little. If so, you may have to give it a whack to pop it loose then use your pusher.
Logged
If guns are outlawed.........
 Only outlaws will have guns.

Offline nevada

  • Full Member
  • ***
  • Posts: 216
Re: trying to remove the factory rear sight on P-01
« Reply #2 on: June 23, 2016, 01:51:23 AM »
You might consider cutting the slide in half with a dremel and cutting wheel. I did that on a SA XDM 45acp sight. worked great.
Logged

Offline Geezer Squid

  • Jr. Member
  • **
  • Posts: 34
Re: trying to remove the factory rear sight on P-01
« Reply #3 on: June 23, 2016, 06:18:37 AM »
Quote from: nevada on June 23, 2016, 01:51:23 AM
You might consider cutting the slide in half with a dremel and cutting wheel. I did that on a SA XDM 45acp sight. worked great.

Assume you meant "sight" not slide!!
Logged

Offline eastman

  • Hero Member
  • *****
  • Posts: 3799
Re: trying to remove the factory rear sight on P-01
« Reply #4 on: June 24, 2016, 04:49:17 PM »
Quote from: Geezer Squid on June 23, 2016, 06:18:37 AM
Quote from: nevada on June 23, 2016, 01:51:23 AM
You might consider cutting the slide in half with a dremel and cutting wheel. I did that on a SA XDM 45acp sight. worked great.

Assume you meant "sight" not slide!!

Just JB Weld it back together and the slide will be fine.



 O0
Logged
I don't look like my avatar!
Pages: [1]   Go Up
« previous next »