CZ 75 SP-01 Manual Safety Tutorial Videos

[Tanners Owner]

I too ran across these searching you tube for how to remove the ambi safety. A great resource I’ll be using. Thanks

However, as I look at my stainless 75b, it doesn’t appear have a pin visible on the ambi / right safety

How do you remove that variant of ami safety?  Any videos anyone can point me to?

[gunbuster]

I found your videos (especially the SP-01s) most educational and informative.  Still new to the CZ mechanics and learning the guts of our beloved CZs sure can be confusing for newer owners.  So again OP thanks for the help creating and sharing these videos.  I hope you see the updates to this thread as your input is greatly appreciated.  Lastly, will you add any new videos?  Perhaps a troubleshooting or FAQs type video?  Thanks again for your time and dedication.  Stay safe and God Bless.

[mkd]

used your videos to install CGW pro pkg,ring hammer, 85 trigger,and rrk on my new sp-o1. great instructionals and thanks for all your effort and sharing.

[dillonguy098]

I used your videos to install the sear spacer from CGW that wasn't installed originally when the upgrade was done. Everything went great until I decided to pull the trigger out to switch the magazine over ( I'm a lefty).When I was putting everything back together I thought the slave pin for the trigger spring was in place. It wasn't and the spring flew into never ever land. I tore my basement apart. I never found it. i ordered 2 of them from CGW. Oh well, definitely a learning experience.

[mkd]

a magnet might find it!   I did the same with the small lifter spring in the sear cage of my p-01 in the office were there is carpet. not once but twice, found it both times. yes it pays to have spares. thread or dental floss i have used to tie the small springs in. then snip the thread when everythings assembled and pull the loop out.

[Old Schoolr]

Thanks for putting out these videos. They were  big help to me in running my pistol thru Schmeky’s “Smoothing the Action” process. Reassembling the sear cage is no where near the Boogie Man the internet has it out to be when you follow your instructions.

[Minfred]

Perfect timing.
Subscribed.
Thank you

[Lock-n-load]

Good job , great reference source!

[bechemeko]

Is this slide fit normal on the CZ 75 SP-01 manual safety?



I would have expected it to be a flush fit like my CZ P-01.: