« previous next »
Pages: [1]   Go Down

Author Topic: Just finished second P01 with Defensive Carry  (Read 1090 times)

0 Members and 1 Guest are viewing this topic.

Offline doc171

  • Full Member
  • ***
  • Posts: 297
  • FIELD MEDICAL TECHNICIAN
Just finished second P01 with Defensive Carry
« on: June 30, 2017, 02:10:56 PM »
This one was a bear of one to get right. With helping hand from David I had to get 3mm drill bit and ream out right side slightly on edge for pin insertion. I installed 85C trigger and found out over travel screw isn't needed at this point. 10X bushing and trits from CGW next.


Sent from my iPhone using Tapatalk
Logged

Offline Tok36

  • Hero Member
  • *****
  • Posts: 6243
Re: Just finished second P01 with Defensive Carry
« Reply #1 on: June 30, 2017, 02:19:03 PM »
Nice pair, glad to hear the mission was successful. I found the same thing in my PCR with factory trigger the frame stops the trigger right after the SA break.
Logged
Will work for CZ pics! (including but not limited to all CZ clones)

Offline Firemanjones

  • Hero Member
  • *****
  • Posts: 5334
Re: Just finished second P01 with Defensive Carry
« Reply #2 on: June 30, 2017, 04:10:45 PM »
Wow, never had that problem with any of my CZs. Glad you were able to work it out.
Logged
Safety First
Living the dream, driving a Fire Engine RETIRED shooting my Guns in FL and the Mountains of NC and visiting family in Mannheim.
Pages: [1]   Go Up
« previous next »