Author Topic: Manticore Arms working on Bren 805 parts  (Read 7189 times)

0 Members and 1 Guest are viewing this topic.

Offline Rick53

  • Full Member
  • ***
  • Posts: 228
Re: Manticore Arms working on Bren 805 parts
« Reply #45 on: January 20, 2018, 05:21:07 PM »
like maxed out my wheeler torque screwdriver at 60 in lbs tight.
60 inch pounds isn't all that tight. I have a Torx wrench designed for the Scar that is permanently set at 65 " pounds. Do you have something to use with more poundage Or a way to use a wrench with the Torx bit? You're probably just a few inch pounds off.
60 inch pounds isn't all that tight. I have a Torx wrench designed for the Scar that is permanently set at 65 " pounds. Do you have something to use with more poundage Or a way to use a wrench with the Torx bit? You're probably just a few inch pounds off.  I personally don't like the wheeler unit for over 20-30 . Just because I don't trust their wrench. My guess is it's 65 . It feels tight because your wrench slips loose at 60. Proper torque isn't an issue when removing something anyway.

Offline Tim07

  • Newbie
  • *
  • Posts: 9
Re: Manticore Arms working on Bren 805 parts
« Reply #46 on: January 20, 2018, 08:02:58 PM »
Any hints on whats coming out? Thanks

Sidefolder stock block (will likely be sold as part of a complete arm brace serup
By SB Tactical)

Revised and improved slider stock

Forend (narrowing it down between three designs right now)

Charging handle

Looking at safeties since the oem ones are marginal

Side folding stock block for an ar buffer tube?

 

anything