« previous next »
Pages: [1]   Go Down

Author Topic: Handle inserts  (Read 1106 times)

0 Members and 1 Guest are viewing this topic.

Offline Stevemacica

  • Newbie
  • *
  • Posts: 1
Handle inserts
« on: February 01, 2018, 12:04:31 PM »
Just purchased a cz 10c and I want to try the different handle inserts, but I cannot remove the roll pin.  It doesn't want to push out and I don't want to deform it.  What am I doing wrong?
Logged

Offline s0nspark

  • Administrator
  • Hero Member
  • *****
  • Posts: 2043
  • System Admin
Re: Handle inserts
« Reply #1 on: February 01, 2018, 01:47:01 PM »
Logged
"A man's character is his fate."

Offline Rickytick

  • Hero Member
  • *****
  • Posts: 1254
Re: Handle inserts
« Reply #2 on: February 01, 2018, 11:00:33 PM »
They are in there pretty good. >:(
Logged

Offline Lifesaver

  • Jr. Member
  • **
  • Posts: 25
Re: Handle inserts
« Reply #3 on: February 02, 2018, 03:27:56 PM »
Push down slightly on the tip where the pin holds in the spring. If not you will repeat what I did which when the pin was removed the spring and the plastic lanyard thing flew out. Fortunately my right eye stopped it from traveling more the 3 feet.lol. No joke. My eye hurt for 2 days. The spring seated in my very disorganized garage but found it 10 minutes later 12 feet away. You've  been warned.lol
Grips made little difference to me but I use the large. I'm  6'7", big hands.
Logged

Offline bigdave24

  • Full Member
  • ***
  • Posts: 406
Re: Handle inserts
« Reply #4 on: February 02, 2018, 11:15:22 PM »
5/64 punch and a heavier hammer should do it.
Logged

Offline cntrydawwwg

  • Hero Member
  • *****
  • Posts: 5254
Re: Handle inserts
« Reply #5 on: February 02, 2018, 11:42:16 PM »
Quote from: Lifesaver on February 02, 2018, 03:27:56 PM
Push down slightly on the tip where the pin holds in the spring.
   It?s a P10c, no hammer spring. [emoji6][emoji87]
Logged
If guns are outlawed.........
 Only outlaws will have guns.
Pages: [1]   Go Up
« previous next »