Author Topic: CZ hammer fit the P-120  (Read 229 times)

0 Members and 1 Guest are viewing this topic.

Offline dirkdiggler

  • Jr. Member
  • **
  • Posts: 36
CZ hammer fit the P-120
« on: February 11, 2018, 08:31:34 AM »
I know CGW sells a hammer kit that fits the p-120 but I was wondering if the your run of the mill CZ 75 SP-01 hammer is compatible with the P-120. Nothing against the P-120 hammer but I like the feel of the hammer on my SP-01.

Offline Underwhere

  • Sr. Member
  • ****
  • Posts: 641
Re: CZ hammer fit the P-120
« Reply #1 on: February 11, 2018, 09:26:49 AM »
I know CGW sells a hammer kit that fits the p-120 but I was wondering if the your run of the mill CZ 75 SP-01 hammer is compatible with the P-120. Nothing against the P-120 hammer but I like the feel of the hammer on my SP-01.
They have a race hammer for the p120. I have it on mine.

 Not sure if it's identical or not... But mine feels exactly the same when I squeeze the trigger.

Offline Underwhere

  • Sr. Member
  • ****
  • Posts: 641
Re: CZ hammer fit the P-120
« Reply #2 on: February 11, 2018, 09:30:24 AM »
I know CGW sells a hammer kit that fits the p-120 but I was wondering if the your run of the mill CZ 75 SP-01 hammer is compatible with the P-120. Nothing against the P-120 hammer but I like the feel of the hammer on my SP-01.
They have a race hammer for the p120. I have it on mine.

 Not sure if it's identical or not... But mine feels exactly the same when I squeeze the trigger.
Sorry I think I misunderstood. You wanted to use a stock cz hammer from the SP01?

Personally I think if you were going through the effort to locate a new hammer I would think you'd be better off just upgrading.

Offline Practical Shooter

  • Full Member
  • ***
  • Posts: 242
  • Life's just too short
Re: CZ hammer fit the P-120
« Reply #3 on: February 11, 2018, 10:00:09 AM »
I measured my Canik P120 hammer width at .239"
I measured my CZ75 Omega width at .311"

From CZCustom :
"Important Note on Hammer Width. Standard CZ 75 Slides have a slide hammer notch width of 0.28" using a hammer width of 0.234". CZ 75 SP01 Shadow, Tactical Sport, and CZ 75 Shadow have a slide hammer notch width of 0.355" using a hammer width of 0.315".

So it look like if my Omega Hammer is the same as the "CZ 75 SP01 Shadow, Tactical Sport, and CZ 75 Shadow"
The Standard CZ75 with 0.234" is like the P120 0.239".
BUT, I haven't checked if the pins holes match up

CZCustom Hammer link:
https://czcustom.com/products/cz-sa-da-sa-only-competition-hammer.html

Over all, it confirms one more time that the P120 looks like an SP01, but is more closely related to the Standard CZ75.
I am also wandering if an aftermarket hammer will correct the occasional hammer bite I get on my Canik.
« Last Edit: February 11, 2018, 10:05:02 AM by Practical Shooter »

 

anything