This was mine, along with Arachnigrip slide spider.
Have Talon grips on all my plastic guns, they help a lot and very easy to install. They last a good long while IF you carefully follow installation instructions. Key thing being to generously scrub the application area with alcohol scrubs (use more than just the small pads supplied), let dry, apply slowly and lightly so you can lift and adjust as necessary. Once where you want it, just grip and squeeze all around, especially edges. Use a blow dryer (not a heat gun) and heat all surfaces for 2 minutes or so to slightly melt underlying adhesive, then regrip in each hand squeezing it down good, again especially edges. Let it set for a bit and good to go. If/when you want to remove it, simply peel it off. It leaves no sticky residue or discolors plastic at all. You can just wipe down grip with alcohol if for some reason you do feel a slight sticky spot and good as new, shouldn?t have to though. They make it in both rubber and the sandpapery like skateboard tape. Both feel rock solid, for extended shooting I personally prefer the rubber but the rougher texture isn?t really hard on the hands at all.
