Any milled RMR's on RAMI without a mounting plate?

[Vinny]

Has anyone done an RMR mount on a RAMI without the plate?
I have an 'extra' RMR01 that I'm considering mounting on my RAMI.  The Rami slide appears to be slightly wider than a CZ 75 and it's certainly flatter.  When I hold the RMR on top of slide there appears to be just enough room for the holes. Then, I'm wondering if there's enough room for a rear iron too??
 
I know I CAN mill/direct mount a small mini-rds like Shield, JPoint, or possibly a Viper where the mount holes are closer together.  But, I already have the RMR01 and I think it would be perfect on the RAMI.

Anyone have experience with this??

Thanks for any info.  -Vinny

[Vinny]

I just measured the width of my RAMI vs.P-01 at rear of slide where RMR would mount; and RAMI is a full .100 wider.
Wondering if there's enough meat there for RMR's mount holes after milling flat??

Trying to achieve a lower RMR mount without a plate, thus shorter front/rear BUIS for holstering.

Anyone done this??