Author Topic: Question on the Bren 16" barrel installation  (Read 473 times)

0 Members and 1 Guest are viewing this topic.

Offline JConnor93

  • Jr. Member
  • **
  • Posts: 65
Question on the Bren 16" barrel installation
« on: April 14, 2018, 06:14:12 AM »
I just got my receiver back from being cerakoted. I completely disassembled the rifle and put it back together. As I was doing this, I remembered I saw a tiny gap between the breach and the shelf that I believe are to prevent the barrel from over traveling. It was present again last night.

All of the screw holes are lined up. So is it safe to believe this tiny gap is meant to be there?

He did cerakote the insides lightly. I do need Yo take material off to properly fit the front sling plate as it'd not sitting flush and preventing the screw from sitting correctly