OWB Kydex Holster for P-01 99041 All Steel SP01 Compact

[WVsig]

I am looking for a kydex holster for my Cajunized P-01 99041. The slide stop on these guns is thicker than the standard P01 slide stop and the standard P01 slide stop will not work with the CGW parts. I am looking at a Vedder Kydex holster but I am not sure that it will accommodate the thicker slide stop. I think it will be a tight fit. It was too wide for my Milt Sparks VMII built for the P01. It would work but would have degraded the retention overtime. With the kydex I am not sure it will even go in. I am considering buying the Vedder and trying but am looking for suggestions.

Can anyone make a good recommendation for a quality Kydex holster for a P-01 99041?

[Dreamer]

I have a 99021 (almost identical to 99041) that works in a Vedder light tuck for a P01, though as you say the slide stop does extend out more than is perhaps ideal. However, with tightened retention screws it works fine. I will probably eventually get a P01 slidestop (doesn?t stick out as far from all reports) to remedy this. 

[WVsig]

I have a 99021 (almost identical to 99041) that works in a Vedder light tuck for a P01, though as you say the slide stop does extend out more than is perhaps ideal. However, with tightened retention screws it works fine. I will probably eventually get a P01 slidestop (doesn?t stick out as far from all reports) to remedy this.

Thanks for the reply. A P01 slide stop did not work for me with the CGWs parts. The hammer will drop with the safety engaged. My understanding is that it is interfering a bit with the safety and if I radius the bottom a bit it will full engage.

[WVsig]

Just to update I picked up a Vedder lighttuck since they were having a sale and it works perfectly with the steel P01 slide stop and the CGW extended safety.