The Original CZ Forum
CZ PISTOL CLUBS => CZ 2075 RAMI CLUB => Topic started by: Bikesroget on July 28, 2016, 07:15:59 PM
-
Hi
Just picked up my Rami
I had trouble finding the sweet spot to reinsert slidestop to reassemble. Can someone save me some time. Simply bringing the slide to the hammer wasn't working. I know I spent way too much time. Any help is welcome. I love the Rami
-
There is a small line stamped in the left side of the frame and slide towards the rear. Bringing the slide to the hammer at half cock should be close enough for you to see the mark and line them up.
-
There is a small line stamped in the left side of the frame and slide towards the rear. Bringing the slide to the hammer at half cock should be close enough for you to see the mark and line them up.
My RAMI does not have the little line and not sure which ones do, but yep, hammer at half cock, bring the slide back to that point.
-
Thanks for your help
-
Back together?
-
Yes
I did it the first time but it took awhile. I saw on sootch00 video where he says you need to line up the right side til it is round then insert the pins.i don't think all have marks.
It seems like it took longer than it should
Thanks
-
Rami does not have the lines, look in the hole to reassemble.
-
Sorry, didn't realize Rami's aren't marked. I've handled them several times but don't own one. That's what I get for making an assumption. I wonder why they left the marks off of them when everything else gets them. Any other CZ pistols that omit the marks?
-
I bring the hammer back to half cocked. Push the slide back until it just contacts the hammer. Bingo!
-
Sorry, didn't realize Rami's aren't marked. I've handled them several times but don't own one. That's what I get for making an assumption. I wonder why they left the marks off of them when everything else gets them. Any other CZ pistols that omit the marks?
The 40P has both lines and dots that align in two different positions. You have to use them both. You start the slide stop at the lines then have to move the slide to align the dots while lightly pressing the slide stop in and it will pop in.
This is how I generally install a slide stop in a CZ. I insert the slide stop partially, then slowly move the slide rearward (to align the markers if present) while applying slight pressure to the slide stop. When things are aligned it will pop into place. That generally happens when the slide is in close proximity to the hammer at half cock.
Cheers,
Toby