Gary, I received your message in email, but cannot find it in my CZ messages, anyway.
I have not had a high demand for this product, mainly I believe due to other knowledge it exists.
But with the low volume of need and the hi cost of product liability insurance, I would be paying people to take them at this point.
I am however still on the prowl to find a lower cost product liability provider so all is not lost yet.
If it ever becomes available I will post it on this site and the YouTube Video also.
Thank You.
PS I have been running this 7075-T6 Aluminum part with only a Mil-Spec type II anidize for testing, i have a older model p10 without the side cut, and a new model with the side cut.
both have had zero issues after initial testing and adjustments after prototyping.
Also the striker clicking over to one side is not fixed by the new model side cut, the striker rotating is due to large play and minimal interference from striker to the slide.
So newer models are still capable of rotating.
