P10C RMR cowitness stock sights

[Dirk]

Had my RMR machine work done at Gunworks Machine in Wichita, Kansas. www.gunworksmachine.com

Sits low on the gun and gives about a 1/3 co-witness with factory sights.

CGW 15lb spring, trigger work, stippling, etc- Love it. It has become my daily...

[Nicefish]

Had my RMR machine work done at Gunworks Machine in Wichita, Kansas. www.gunworksmachine.com

Sits low on the gun and gives about a 1/3 co-witness with factory sights.

CGW 15lb spring, trigger work, stippling, etc- Love it. It has become my daily...

Dirk, I'm saving up to get an RMR and slide milling and should be able to get it done around Christmas.  You said that the RMR sits low enough to get 1/3 cowitness with factory sights - that has got me excited.  If you don't mind me asking (?), about how much did it cost you?  Thanks.

[Dirk]

Honestly don't remember the cost. Around $100.00 or so, I think. I had the slide redone as well with one of their high tech coatings, so that was a bit more.

I love how low it sits with no need for suppressor height sights. Trying to find a pic to post, but don't have any online aside from on my puter...

[Nicefish]

Honestly don't remember the cost. Around $100.00 or so, I think. I had the slide redone as well with one of their high tech coatings, so that was a bit more.

I love how low it sits with no need for suppressor height sights. Trying to find a pic to post, but don't have any online aside from on my puter...

If you could find one I'd be very interested to view it.  I was pondering sending my P10c to one of the popular well known machine shops (on this forum).  Originally wanted the cut and re-nitride of the milling, and the black suppressor height sights (not any of the fancy stuff): but if I could get the factory tritium night sights to cowitness 1/3 - that would be ideal on several fronts.  I may just reach out to them; thanks for the vine.  PS - regarding the sights, another great alternative would be if Dead Air makes their flip up suppressor Glock sights available for CZ/other makes.  Reached out to them and they implied they intended to but for now they are just going after "the low hanging fruit".  Was concerned that over the last couple of weeks the price went from $120 to $140 and now to $190?  One of the machine shops offered to mill out the P10c rear to fit Glock sights, but they could not do the front.   Wonder why?