« previous next »
Pages: [1]   Go Down

Author Topic: Problem with my 97  (Read 1416 times)

0 Members and 1 Guest are viewing this topic.

Offline gtcooper

  • Full Member
  • ***
  • Posts: 163
Problem with my 97
« on: October 21, 2018, 09:26:37 AM »
My trigger bar seems to be getting ?stuck? or caught under the firing pin block lever. Number 14 in the attached diagram. I can push the bar down and it gets caught pull the hammer back and it will pop back up. I check the trigger bar spring. It is riding in the groves. Pulled it up to put more tension on it. Still same issue. Any ideas?


Sent from my iPhone using Tapatalk Pro
Logged

Offline gtcooper

  • Full Member
  • ***
  • Posts: 163
Re: Problem with my 97
« Reply #1 on: October 21, 2018, 02:11:24 PM »
Was converting to sao. So I removed the disconnector. Reinstalled disconnector and it works fine.


Sent from my iPhone using Tapatalk Pro
Logged

Offline Tok36

  • Hero Member
  • *****
  • Posts: 6243
Re: Problem with my 97
« Reply #2 on: October 21, 2018, 02:35:25 PM »
You might try increasing the TBS tension on the right side a bit. It sounds like the trigger bar is riding too low. Normally it should not be able to pass under the FPB lifter arm.
Logged
Will work for CZ pics! (including but not limited to all CZ clones)
Pages: [1]   Go Up
« previous next »